Flo-tech
Flo-tech began in 1961 with the introduction of its first generation PFM portable tester. Over the years, the Flo-tech tester line has undergone a progression of design changes that have enhanced its operational features while maintaining the rugged dependability of that first tester.
Select a Filter Below
- CATEGORY
- Flow Meters ()
- Turbine / Paddlewheel Flow Meters ()
- Panel Meters / Digital Indicators ()
- Temperature Transmitters / Transducers ()
- APPLICATION
- ()
Compact, lightweight, portable tester simultaneously measures flow, pressure & temperature
Bi-directional tester simultaneously measures flow, pressure & temperature with an internal pressure relief system
Handheld turbine flow meter system with inputs for 2 pressure sensors, 1 temperature sensor & 1 active pick-up for RPM measurements
Starting at
$2,335.00
Measures flow rate providing frequency or analog output, choice of high strength aluminum or Stressproof® steel bodies
Starting at
$605.00
Provides analog output for flow, temperature & pressure in a compact unit
Starting at
$995.00
Measures flow, temperature, pressure & power from one point with pressure surge protection & a large membrane switch
Starting at
$2,865.00
Stationary or portable tester for both industrial & mobile hydraulic systems measures flow, pressure & temperature
Starting at
$3,835.00
Two-wire platinum RTD element with 4-20mA electrical output
$325.00
Simultaneously measures flow, pressure & temperature of hydraulic fluids with a pulse output for flow
Starting at
$760.00
Accepts frequency signals from Flo-tech's Ultima & Classic turbine flow sensors, powered by either an AC or DC power source
Starting at
$555.00
Digital displays for Activa and Classic flow sensors with analog output & 4-20mA or 0-10VDC inputs
Starting at
$495.00
High strength aluminum body, provides bi-directional flow rate measurement with four flow ranges
Starting at
$835.00
Polysilicone strain resistors create very low noise levels with a very high signal output
Starting at
$580.00
Five or ten point calibration certificate for the USB hydraulic system analyzer
Starting at
$381.81
Makes the Flo-tech F5140 K Factor Scale field adjustable converting frequency output of a turbine meter to a different frequency
$175.00
Cables for connecting Flotech IFC, Activa, Ultima, Classic & Quad to displays, choice of 6 or 15ft lengths
Starting at
$80.00
Pre-amplifier for low level turbine meters converts low level frequency outputs into square wave output signals
$225.00
Pressure sensors for use with the Flo-tech MC4000 Hydraulic System Analyzer
Starting at
$425.00
8 foot pressure transducer cable for use with the Flo-tech MC4000 Hydraulic System Analyzer
$80.00
Pressure sensor connector for use with the Flo-tech MC4000 hydraulic system analyzer
$20.00
90° pressure transducer connector for use with the Flo-tech MC4000 Hydraulic System Analyzer
$20.00
8 foot long 5-pin cable for flow, pressure & temperature, for use with the Flo-tech MC4000 hydraulic system analyzer
$270.00