Honeywell Enforcer Automatic Calibrator

The Honeywell Enforcer Automatic Calibrator calibrates Lumidor Impact and Impact Pro multigas monitors fitted with oxygen, flammable, carbon monoxide and hydrogen sulfide sensors in less than two minutes. Volumes and flow rates are minimized to allow approximately 200 calibrations per cylinder of gas, making the cost of calibrations as low as $1. Impact instruments, when used with The Enforcer, are always available for use. Calibration results are recorded for printing at a later date via the optional PC software, thereby ensuring that instrument histories are always available if required.

Workplace safety regulations require regular testing of gas monitoring equipment to ensure that the instrument will work as and when required. The Enforcer Calibration Accessory allows you to easily comply with regulations when using a Lumidor Impact or Impact Pro multigas monitor, without the need for costly test facilities or third testing.

‘Bump' testing should be carried out before use of any portable gas detector. This involves exposing each gas sensor to a known concentration of target gas and ensuring that it responds correctly. If not, the unit must be re-calibrated or serviced to replace those parts not working.

Personal gas monitors are normally calibrated every 3 to 6 months. Typically this requires specialist knowledge and equipment that is costly, or the work is sub-contracted to a third party. During this time, instruments are not available for use and so could delay essential operations or force additional monitors to be purchased.