Fluke Calibration Conversion Weight Set (formerly Pressurements)
Starting at $2,150.00

Not in stock. Call for availability [?]

Need Help? Call a Calibration Engineer 1-800-884-4967

We're open 8:00am to 5:30pm ET


  • Pressure units: psi, bar, mbar, kPa, MPa, kgf/cm2, inH2O, inHg, mmHg
  • Pressure or vacuum ranges available
  • Range to 500 psi (or equivalent)

This product is an accessory for the following products:

Fluke Calibration P3000 Pneumatic Deadweight Testers (formerly Pressurements)
Pressure ranges from vacuum through 2,000 psi (140 bar) with accuracy greater than 0.015% of reading

The Fluke Calibration conversion weight sets allow a deadweight tester to calibrate in different pressure units without the need to perform conversion calculations. The weight sets are adjusted to the correct mass for use with the existing piston. Each weight set includes a replacement low-pressure weight carrier table and a replacement high-pressure weight carrier ring. These items are simply exchanged for the original items when using the conversion weights.