If you have a question not answered here please submit it to Ask an Engineer or call 800-884-4967.

This recorder is a multi-input device which permits the input for any channel to be changed to thermocouple, RTD or DC voltage input. Follow the procedure described below to change the input type.

Step 1:

Turn off the power to the unit.

Step 2:

Open the front door and remove the main unit in the manner shown in the drawings below.

Step 2-1:

Remove paper tray from unit by pressing the release button and pulling paper tray forward.

Step 2-2:

Loosen the lock screw (M4) inside the recorder using a Phillips type screwdriver.

Step 2-3:

Hold the lower base plate at the square hole and forcedly pull it forward. The recorder will be removed from the case.

Step 2-4:

Change the settings of the pins for individual channels on the internal printed circuit board. Use pliers to remove and insert pins.

Step 2-5:

After completing the hardware change, push the main unit back into its original place and screw back into position.

Step 2-6:

Change the input terminal wiring to make it correspond to the new input signal type. For DC current input, provide the input terminals with shunt resistors.

Step 2-7:

Refer to Section 7.8 in the manual and carry out the programming changes for each channel that has been modified.