• 2115.75
  • Not in stock. Usually ships in 1-2 weeks


  • Small, compact size
  • Measurement range of 0.5 to 240AAC
  • Large jaw opening accommodates conductors up to 250MCM
  • Designed for DMMs, loggers, recorders and oscilloscopes
  • 40Hz to 10kHz response
  • 1mAAC/AAC output signals
  • Designed to EN 61010, 600V Cat. III safety standard
  • UL approved for Canada and United States
  • Double Insulation
  • CE Mark

This product is an accessory for the following products:

The AEMC MN213 compact AC current probe is designed to meet the most stringent demands in industry and electrical contracting. The MN213 meets EN 61010, 600V, Cat. III safety standards and is CE Marked and UL approved for Canada and United States.

The AEMC MN213 has an 0.83" jaw opening and can accommodate conductors up to 250MCM. The unique hooked jaw design facilitates clamping and hooking onto conductors. Polycarbonate materials and ultrasonic welding are used throughout to ensure ruggedness and overall lasting reliability.

The AEMC MN213 uses tape-wound cores to further improve its high and low end performance. Rated at 200Arms it has a measurement range to 240Arms.

AEMC MN213 AC current clamp specifications:

Nominal Range 200 A
Measurement Range 0.5 to 240 A
Transformation Ratio 1000:1
Output Signal 1 mA/A on 1 Ω
Accuracy (200 A Range) 0.5 to 10 A: 3.0% of reading ± 0.5 A
10 to 40 A: 2.5% of reading ± 0.5 A
40 to 100 A: 2.0% of reading ± 0.5 A
100 to 240 A: 1.0% of reading ± 0.5 A
Phase Shift (200 A Range) 0.5 to 10 A: not specified
10 to 40 A: ≤5°
40 to 100 A: ≤3°
100 to 240 A: ≤2.5°
Overload 240A for 10 min ON, 30 min OFF
Frequency Range 40 to 10 kHz
Limit Operating Conditions 200A permanently to 1kHz; Derating above 3kHz: 200A x (1/0.333F), F in kHz
Crest Factor 3 @ 200 Arms with an error (due to CF) of 4%
Working/Common Mode Voltage 600 Vrms
Output Termination 5 ft lead
Jaw Opening 0.83"